by Lukenz » Tue Jun 02, 2020 9:37 am
Hi Geeves, thanks for your reply, yes brand new cylinder head, the new gasket came with instructions. this is all in sequence shown from middle outwards
1. 20
2. 50 Nm
3. loosen all bolts
4. 52 Nm
5. +60 degrees
6 +60 degrees
7 +30 degrees
I'm not sure what it says in the isuzu manual and if I should be following different instructions? I have pulled the head of today, i can't see any evidence of the leak since it wasn't run very long, i will order new gaskets and studs, just be nice to cover all basis so I don't have to do it another time! lol I've obviously done something wrong, just not too sure what.. I've heard people putting copper coat on the gaskets, I don't know if this benefits anything and if its something I should do, im not sure. cheers