OBD2 Tech2 USB Cable Auto Scanner Diagnostic Tool Interface

[FronteriaPete]

Hi,
I am have a intermittent fault, and the dealer can not see the fault when the vehicle is in with the dealer.
i purchased a..
OBD2 Tech2 USB Cable Auto Scanner Diagnostic Tool Interface For Opel Vauxhall
http://www.ebay.com.au/itm/161369088040 ... 1497.l2649
The first thing I noticed is it is not advanced as I would of though. I addition I can not get it to communicate, but I notice it has a BAUD rate of 10700, and it can not be changed? I suspect it is trying to communicate, but get rubbish. Laptops do 9600, next is 14400. Is 10700 standard in CHINA? There are a few you tubes of set up, but the baud rate is not addressed, and no one actually using the ODB2 TECH2 USB. The vehicle type in the graphic is a Frontera- B- mine vehicle is a "Holden(Isuzu) MX 4WD Year of manufacture August 2001"- I think is "B". But the baud rate is the big problem stopping communication? I think....

I wonder if any one else has used such a OBD device?

Hope some one can advise !
Cheers,
Peter.

[geeves]

only suggestion I have is did you install the driver to your pc as per instructions. It should automaticly set the usb port correctly

[FronteriaPete]

Hi Alan, thanks- yes- I will go through the set up process again, and see if the BAUD rate gets set correctly. Hopefully I am missing something. Comments appreciated.
Cheers for now. Regards, Peter.