by damo667 » Fri Oct 12, 2012 3:32 am
I replaced the central bearing about 6 months ago and n play in u-joints and I've checked for play in the wheels also the drive shaft has way more play then before if you turn it from side to side whilst stationary,
Diff has been making a bit of noise on and off for a while ie tight low speed corners and steep inclines but whereas is normally give a couple of clunks it was clunking alot more on wed,
Strangely after being parked up all night driving it yesterday seemed relatively normal.. just occasional clunk!!
There is a 96 Bighorn LSD Diffhead on trademe I was just wondering if it would fit straight without too much hassle
I was hoping its just a case of unbolt hubs, slide axles out, unbolt drive shaft, unbolt diff head from housing, throw in lake!, fit LSD head, drive away!!
Am I being optimistic there? Is there any difference between the 2003 and 96 diffs?
Cheers
vroom..._____________...........
vroom./---------|--------\.......
..&.....||______|_____O-\______....
....&...|--____---------------____--\..
........=\/-----\__________/-----\_|...
............\___/..................\___/...