hey guys
yesterday i received and installed the OME 919 rear lift kit on my Isuzu. for a first timer i think i did an OK time to install it. 3hrs by myself
. anyways, it gave me a good 2" (50mm) rear lift. i didn't replace the shocks due to unavailability at the shop but will do next week. now for the front part i got somehow stuck.i took the torsion bars as far as they could go. it gave me another 15mm front lift. Nnow i have a difference of 25mm from front to back.
1)Is that ok or will i have to do the ball joint flip?any ideas/suggestions?
2)As far as the front sway bars, do you you guys take them completely off or just unbolt them?wouldnt they get in the way then?
3)Rear sway bars on my car are electronically controlled.Not sure if that thing still works though (i did some efforts to check it while the wheels were up in the air yesterday, didn't see any change to the height....not sure if what i did was correct... ) anyhow, can i disconnect the rear sway bars also?will that be ok or no? (as far as the driving attitude i saw what GEEVES told me and keep that in mind for now) other than that?
cheers